PPWR Article 7 · research beta

Recycled-content readiness check

Enter one packaging unit. You get back which of the Article 7 recycled-content targets apply to each plastic part, how far the plant’s average is from the 2030 and 2040 figures, and what is still missing to say more. Every line cites its article, and where the answer cannot be known, it says so rather than guessing.

About 5–10 minutes. Have to hand:

  • the total packaging weight, and each part’s weight and material
  • for plastic parts: contact-sensitive or not, beverage bottle or not, PET-based or not
  • if you have it: the recycled content the manufacturing plant supplied to you over the year, for this packaging type and format

Start the check or load the example to edit

No account. Your inputs are processed in the EU, not stored and not used for AI. Aliases are fine for the SKU and the plant.

BTL-500 sample report ruleset 0.6.0 · 2026-10-05

bottle · PET · 26 g · food contact
plant Münster-1 · 2026 average: 28 % recycled

Future target

Recycled content, single-use plastic beverage bottles

The plant averages 28 %, 37 points short of the 65 % the rule asks for from 1 January 2040.

Source: Article 7(2)(c)

What to do: raise the plant’s annual average for this format to at least 65 % before 2040.

Future target

The same bottle against the 2030 figure, 30 %

2 points short. It binds on “1 January 2030 or three years after the Article 7(8) implementing act, whichever is later”. That act is not in the ruleset yet, so the report keeps the date open rather than guessing it.

Excerpt from the sample report. Read all of it

Scope: Article 7 (minimum recycled content in plastic packaging) only. This is not a PPWR conformity assessment, which spans Articles 5 to 12 and the Annex VII procedure; it does not cover substances of concern, recyclability, compostability, minimisation, reuse or labelling. Within Article 7 it does not check whether your recycled content qualifies under Article 7(3), or your Annex II type and format grouping: both are taken as you enter them.

Packaging unit
If Yes or Not known: which one
Component 1

For plastic parts, and composite or other parts that contain plastic. Leave blank for paper, glass, metal or wood.

Manufacturing plant

Article 7 is an average per manufacturing plant, per calendar year and per packaging type and format, of what that plant made for your company (Commission PPWR FAQ). The plant is where the packaging was made, usually your supplier’s, not the filling line. One check covers one plant and one type and format: if your parts come from different plants, as a tray and its lid often do, run one check per plant with only that plant’s parts. Leave anything you do not know blank and the report will list it as missing. Not needed if no part is plastic.

Stuck on a question, or missing the data? Tell us where.

or see the full sample report

No account. Your inputs are processed in the EU, not stored and not used for AI. Aliases are fine for the SKU and the plant.

Stuck on a question, or missing the data? Tell us where.

Informational use only. This report is generated from a written set of rules derived from Regulation (EU) 2025/40. It does not constitute legal advice or a legal service within the meaning of the Rechtsdienstleistungsgesetz, and it does not establish or certify compliance. The ruleset may be incomplete and may not reflect later amendments, implementing acts or national law. Verify every result against the official text before relying on it.